Skip to content

Yamaha Interface Cable Installation Video

Posted in Videos

Yamaha Interface Cable Installation

Yamaha Interface Cable Installation –¬†Are you looking to get your Yamaha Engine Data displayed on your Lowrance HDS GPS/Plotter? This video can help you do just that. The plug is covered by a white cap towards the front of the engine. Just behind the front latch. There is a white cap that protects the cable end and it must be removed. After removal, slide your new cable end on and make sure it clicks into place. Your Yamaha Interface cable is now ready to be hooked to your network. Run the wire through the motor cluster and pull it up to your Lowrance Unit. Hook to the NMEA 2000 Network and you are ready to roll!

You can also visit our other videos at our youtube channel here. Enjoy!

Be First to Comment

Leave a Reply